Gas and Air Solutions: Hvac Maintenance for Homeowners

Your water heater is one that is used and more appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and energy costs.

Regular flushing of the water heater has become single most important step you get to prolong its service life in addition, it save energy. For time, sediments mount up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regarding the country, the normal water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is a must in today’s weather. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a nights.

To drain your water heater, which will help should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to water heater. Next, close the water supply valve located on a water inlet line going into your water heater. You can then connect a hose to the drain valve located in the bottoom of the heater tank. Open the drain and allow it to play until all of the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until drinking water flows out perfectly. This will allow air to vent inside heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas which have hard wetness. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to fit the bill.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2

Bookmark the permalink.